b) Mounting the Elevator and Rudder Linkage Rods
Put the rudder horns of the servos for elevator and rudder at precisely 90° to the servo casing (also see figure 8,
item 4 + 5).
Shorten the rods for elevator and rudder at the dampening areas by twisting the clevises in or out so that the dampen-
ing surfaces are in neutral position.
Screw the clevises at the rudder horns on with a suitable tool so that the clevises move freely with a little play
(1 and 2).
For elevators and rudders, the clevises should be attached to the second-to-last, outer hole of the rudder horn for the
first flights. The correct function is explained in chapter "Checking the Control Functions".
Figure 4
52