Charge Flight Battery - Reely Wild Hawk 1380197 Bedienungsanleitung

8. Charge flight battery
Figure 1
Before the final assembly of the model, you should charge the flight battery (1). A suitable mains adapter (2) and a
suitable balancer charger (3) are included in model's scope of delivery.
The 2-wire connection cable at the rechargeable battery (4) supplies the drive motor with power. This cable is later
connected to the flight controller in the model (also see figure 8). This cable must not be connected to the flight
controller while charging.
The rechargeable battery is charged via the 4-pole connection cable (5), which is connected to the right output socket
of the balancer charger. The two snap tabs of the reverse-polarity protected connector must point upwards.
Connect the round plug (6) of the plug-in mains unit (2) to the corresponding socket of the balancer charger (3). Plug
the plug-in mains adapter into a proper mains socket of the public mains. The green power LED (7) in the plug-in
mains unit will then light up and so will the red LED (8) in the balancer charger.
Now connect the flight battery (1) to the right socket (5) of the charger. The charging LED (9) then flashes green to
indicate that the flight battery is being charged.
Charging is completed when the charging LED (9) at the charger remains lit. The flight battery can now be discon-
nected from the charger. Then disconnect the mains adapter from the mains socket.
48