Rudder Function - Reely Wild Hawk 1380197 Bedienungsanleitung

Rudder function

If the control stick for the rudder function is moved to the left, the rudder must deflect to the left. The rear rudder edge
must be deflected to the left by approx. 25 mm. In flight, the landing gear is pressed to the right and the model flies
to the left.
,
If the control stick for the rudder function is moved to the right, the rudder must deflect to the right. The rear rudder
edge must be deflected to the right by approx. 25 mm. In flight, the landing gear is pressed to the left and the model
flies to the right.
If the rudder does not deflect as described above, the "Servo-Reverse" function at the transmitter must be
used to change the running direction of the servos. Further information on this can be found in the operating
instructions for the remote control.
Motor Function
Attention!
Ensure that no loose parts, such as paper, film or other objects can be sucked into the rotor during this motor
test. Also make sure that the model is held securely during this test run and that no clothing and body parts
are within the rotation range or danger area of the rotor.
• Push the control lever for the motor function to the bottom position.
• First start the transmitter, then the model. Depending on how the flight controller is programmed, the flight control-
ler's readiness for operation is signalled by different sounds.
60
Figure 14
Figure 15
Figure 16