Setting Up The Model Helicopter; A) Charging The Helicopter Battery - Reely Earthquake Bedienungsanleitung

10. Setting up the model helicopter

The helicopter battery can be charged using the USB cable provided.
The charging cable in figure 4 is wound up. Before first use, remove the cable tie and fully unwind the
charging cable.

a) Charging the helicopter battery

Connect the USB plug on the charging cable (1) to a USB
port on a computer/laptop or a USB charger plug.
Insert the reversible connector (3) on the charging cable to
the connection plug (4) on the helicopter battery.
When the red LED charging indicator (2) of the charging
electronics lights up in the USB plug, the rechargeable
battery is charged. When the charger LED goes out, the
charging process is completed.
Disconnect the helicopter battery from the charging cable
immediately after charging and unplug the USB plug on the
charging cable from the computer/laptop or charger plug.
Important!
Do not connect the USB cable to a USB hub
without its own power supply (e.g. a USB port
on a keyboard), as the current is not sufficient
to charge the battery.
The operating system will not detect any new hardware
when the charging cable is connected, as the USB port
is only used to charge the battery. Please note that most
USB ports on computers/laptop are only active when the
computer/laptop is switched on.
We therefore recommend that you only connect the charg-
ing cable to a computer/laptop that is switched on.
Important!
Only charge the helicopter battery using the USB charging cable provided. Never attempt to charge the
battery with a different/incompatible charger! Always remove the battery from the helicopter before charg-
ing it. Never charge the battery when it is still in the helicopter. Only charge the battery when you are able
to monitor the charging process.
Figure 4
33