Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Restoring the factory settings
assign it to a room. You can also make individual pa-
rameter settings. Now you can use the "WebUI" user
interface to control your device, configure it, connect it
directly to other devices, or use it in central control unit
programs. Please refer to the HomeMatic WebUI Man-
ual for more details (you can find this in the "Down-
loads" area of the website www.homematic.com).
7.2 Operating functions after teach-in
After the teach-in has been performed, simple operat-
ing functions are available depending on the taught-in
device: Short / long button press.
8
Restoring the factory settings
The factory settings of the flush-mounted remote con-
trol can be restored manually. Resetting takes place
in 5 stages:
• Remove rocker from rocker adapter.
• Hold down the Config button (B) for at least 4
seconds with a pointed object (e.g. pen) until the
LED starts to flash red slowly. Now release the
button again.
• Press the button again for at least 4 seconds until
the LED flashes red rapidly, then release the button
58
again.
• The device has now been reset to the initial state.
• Now replace the rocker on the rocker adapter. The
device can be taught-in again.
9
Device LED feedback
9.1 Flashing codes and error messages
This information applies to operation with and
without a central control unit.
Flashing
Meaning
code
1 x red,
LED test display
green and
orange flash
1 x long,
Device defective
2 x short red
flashes
1 x long and
Duty cycle
1 x short red
flash
Device LED feedback
Solution
Once the test
display has
stopped, you can
continue.
Please contact
your retailer.
(see sec. "9.3
Duty cycle ex-
ceeded" on page
62)
59
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
