Operation; Teaching-In; Teaching-In Directly To Homematic Devices - Homematic Hm-Rc-2-Pbu-Fm Installations- Und Bedienungsanleitung

Installation
Step 11: Now, actuators or a central control
unit can be taught-in to the remote
control (see sec. "7.1 Teaching-in" on
page 53).
Step 12: Secure the rocker to the remote
control with the adapter, and hold the
frame in front of the device.
Position the adapter so that both
latching lugs fit into the existing elon-
gated holes.
52
7

Operation

7.1 Teaching-in

Please read this entire section before starting
the teach-in procedure!
To integrate the remote control into your HomeMat-
ic system and enable it to communicate with other
HomeMatic devices, you must teach it in first. You can
teach-in the remote control directly to other HomeMat-
ic devices (e.g. HomeMatic switch actuator) or to the
HomeMatic Central Control Unit

7.1.1 Teaching-in directly to HomeMatic devices

If you want to teach-in the remote control to one or
more HomeMatic devices, you must put the devices to
be connected into teach-in mode.
During teach-in, please make sure you
maintain a distance of at least 50 cm between
the devices.
To teach in, proceed as follows:
• Place the rocker adapter to facilitate later operation
Operation
53