Configuring Newly Taught-In Devices - Homematic Hm-Rc-2-Pbu-Fm Installations- Und Bedienungsanleitung

Operation
To teach-in your device to the central control unit,
proceed as follows:
• Open the "WebUI" user interface in your browser.
Click the "Teach-in devices" button on the right-hand
side of the screen.
• To activate teach-in mode, click "Start teach-in
mode".
• Teach-in mode remains activated for 60 seconds.
An information box shows how much teach-in time
remains.
• Within this teach-in time, activate the teach-in mode
56
of the remote control by briefly pressing the Config
button (B) with a pointed object (please see sec.
"7.1.1 Teaching-in directly to HomeMatic devices"
on page 53).
• The remote control is now in teach-in mode. The
device LED flashes orange continuously to indicate
this. (To exit configuration mode, briefly press the
Config button again.)
• After a short time, the newly taught-in device
appears in the inbox of your software interface. The
button "Inbox (x new devices)" indicates how many
new devices have been taught-in successfully.
• If required, you can teach-in additional devices
by repeating the steps described above for each
device.
• Now configure the newly taught-in devices in the
inbox as described in the next section ("Configuring
newly taught-in devices").

7.1.3 Configuring newly taught-in devices

Once you have taught-in your device to the HomeMat-
ic Central Control Unit, it is moved to the inbox. Here,
you must configure the device and its associated
channels in order to make them available for operating
and configuration tasks. Give the device a name and
Operation
57