Teaching-In To A Homematic; Central Control Unit - Homematic Hm-Rc-2-Pbu-Fm Installations- Und Bedienungsanleitung

Operation
of the channel buttons during teach-in.
• Briefly press the Config button (B) of the remote
control using a pointed object (e.g. a pen) in order to
activate the 20 second teach-in mode. Depending on
the rocker adapter, you can reach it either through
the rocker or diagonally from above. The device LED
flashes green.
• Press the rocker adapter shortly to activate teach-in
mode for direct teaching-in.
• A continuous orange flashing of the device LED
indicates that teach-in mode is active. (To exit
configuration mode, briefly press the Config button
again.)
• Now put the device you want to teach-in to the
remote control into teach-in mode by following the
relevant operating manual instructions.
• As soon as both devices have completed the teach-
in procedure, the LEDs go off and the taught-in
device can be operated via the remote control.
If no teach-in operations are carried out,
teach-in mode is exited automatically after 20
seconds.
If other devices are also in teach-in mode, they
will be taught-in.
54
7.1.2 Teaching-in to a HomeMatic Central Control
Unit
Your device can be conveniently
• controlled and configured,
• connected directly to other devices or
• used in central control unit programs
by using the HomeMatic software "WebUI". Therefore,
your device has to be taught-in to the HomeMatic
Central Control Unit first. New devices are taught-in to
the central control unit via the HomeMatic "WebUI".
A soon as a component has been taught-in to a
central control unit, it can only be connected to
other components via this unit.
Each component can only be taught-in to one
CCU.
During teach-in, please make sure you
maintain a distance of at least 50 cm between
the devices and the central control unit.
Operation
55