Before First Use - ZANKER KDT 10032FK Benutzerinformation

Deactivating the rinse aid dispenser
While the appliance is in user mode:
1. Press .
• The indicators
• The indicator
• The indicator
(factory setting).
2. Press to change the setting. The indicator
3. Press the on/off button to confirm the setting.
Activating the acoustic signal for the end of programme
By default this acoustic signal is deactivated but it is possible to activate it.
While the appliance is in user mode:
1. Press .
• The indicators
• The indicator
• The indicator
2. Press to change the setting. The indicator
3. Press the on/off button to confirm the setting.

Before first use

1. Make sure that the current level of the water
softener agrees with the hardness of the water
supply. If not, adjust the level of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
8
, and go off.
continues to flash.
indicates the current setting: the indicator
, and go off.
continues to flash.
indicates the current setting: the indicator
on = Rinse aid dispenser activated
off = Rinse aid dispenser deactivated.
off = Acoustic signal off.
on = Acoustic signal on.
5. Start a programme to remove any processing
residuals that can still be inside the appliance. Do
not use detergent and do not load the baskets.
When you start a programme, the appliance can take up
to 5 minutes to recharge the resin in the water softener.
It seems that the appliance is not working. The washing
phase starts only after this procedure is completed. The
procedure will be repeated periodically.