ZANKER KDT 10032FK Benutzerinformation Seite 7

2. Press to change the setting. Each time you press the button, the level number increases. After level 10
you will start again from level 1.
3. Press the on/off button to confirm the setting.
The water hardness table
German degrees
(°dH)
47 -50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1) Factory setting
2) Do not use salt at this level.
Adjusting the rinse aid level
You can set the released quantity of rinse aid between level 1 (minimum quantity) and level 6 (maximum quantity).
Level 0 will deactivated and no rinse aid will be released.
Factory setting: level 4.
While the appliance is in user mode:
1. Press .
• The indicators
• The indicator
• The indicator
+ 4 flashes = level 4)
2. Press to change the setting.
3. Press the on/off button to confirm the setting.
French degrees
(°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
<7
, and go off.
continues to flash.
starts to flash. The number of flashes indicates the current setting (e.g. 4 flashes + pause
mmol/l
8.4 - 9.0
7.6 - 8.3
6.5 - 7.5
5.1 - 6.4
4.0 - 5.0
3.3 - 3.9
2.6 - 3.2
1.9 - 2.5
0.7 - 1.8
<0.7
4x
Clarke degrees Water softener level
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
10
9
8
7
6
5 1)
4
3
2
1 2)
5x
7