Rowi HGS 2000/2 T Originalbetriebsanleitung Seite 34

GB Fig. 2c: Operation
3. Puncturing the gas cartridge:
Make sure that the rotary knob for setting the heating power is set on the "0"
position.
Then move the lever to load the cartridge by pressing it downwards onto the
"Load" position
4. Switching on the appliance:
Turn the rotary knob anticlockwise to the "MAX" position. Keep turning until
you hear an unmistakable "click" sound.
When the flame turns on, hold the rotary knob on the "MAX" position for
approximately 10 seconds before starting to set the flame strength.
5. Setting the heating temperature:
If there is no flame, repeat step 4.
Turn the rotary kno
strength.
to the desired position to achieve the desired heating
b
34/44