Saving A Measurement - Silvercrest SNWD 1000 A1 Bedienungsanleitung

Saving a measurement

You can save all displayed values for a food. The scales will automatically add
the values to each saved measurement. For instance, you can enter every item of
food you eat over the course of a day and view the data at the end of the day.
The saved values are retained, even after you switch off the scales or change the
battery.
You have previously performed a measurement and entered the code.
1) Touch the M+
and energy values. "M" plus the weighing number (e.g. 01) flash in the
display
NOTE
► You can only save measurements for which you have also entered a
code.
► If make a mistake when entering the code, you can only change the
code before saving by entering it again. It is not possible to change the
code subsequently.
2) Proceed in the same way to save further nutritional values. The weighing number
is increased by one after each save. The number from the last weighing is
displayed.
NOTE
► The memory can store up to 99 measurements. After this, no further
measurement can be saved and "M99" flashes in the display
To be able to save further measurements, delete the saved data by
pressing the MC
► Note that pressing the MC
saved previously.
► If the total for a saved nutritional or energy value exceeds the maximum
value, the display
function, "M" and the digit from the last process both flash to indicate
that no more measurements can be saved. The following maximum
values apply:
■ 10 │ GB │ IE │ NI
button to save the measured weight along with the nutritional
for about 10 seconds after the total symbol Σ.
button. The display M99 goes out.
will show "E- - - -" there. After exiting the memory
Kilocalories
Fat
Carbohydrates 9999.9 g
Protein
Cholesterol
button will delete all measured values
99999
9999.9 g
9999.9 g
9999.9 mg
.
SNWD 1000 A1