Switching The Scale Off; Saving A Measurement - Silvercrest SNAW 1000 A1 Bedienungsanleitung

4) To recall the nutritive and energy values, press the desired function button 8.
The required detail appears in the display 3.
If no further buttons are pressed, after approx. 8 seconds the display changes
back to the weighing mode and the weight is indicated. If you wish toswitch
straight into the weighing mode, press the button
the weight.
NOTICE
Should you press a function button 8 (except
►
code has not yet been entered, "Code" blinks in the display 3 3 times.
In this case, enter in the desired code.
NOTICE
► Due to natural fl uctuations in the energy and nutritional values, only
approximate are possible.
Switching the scale off
To switch the scales off , press the button ON/OFF TARE
The scales switches itself off .
or
Wait for about 60 seconds after the last usage. The scales switches itself off
automatically.

Saving a measurement

You can save all indicated values of a foodstuff . The scales automatically adds to-
gether the values each saved measurement. . Thus, for example, you can save your
entire food values eaten in one day and recall them at the end of the day. The saved
values are retained, even when you switch the scales off or change the batteries.
You have previously made a measurement and entered the code.
1) Press the save button
pears "M", the save location (e.g. 01) and the weight. M01 (or the last occupied
space) is shown permanently on the display 3.
NOTICE
► If you press the save button
a code, "Code" blinks 3 times in the display 3. Then enter in the required
code.
2) When you want to carry out and save the next measurement, press the save button
M+
3) To make further measurements, repeat the previously described steps.
SNAW 1000 A1
4 to save the measurement. In the display 3 ap-
M+
4 once again. In the display 3 the next save position (e.g. M02) appears.
de
,
4 without having previously entered in
M+
The appliance indicates
), although a
de
for about 3 seconds.
115
GB