Replacing The Oven Light - Atag OX6211P Bedienungsanleitung

A
Fig. 28
DO NOT clean the oven door while the glass
panels are warm. If this precaution is not
observed the glass panel may shatter.
If the door glass panel becomes chipped or
has deep scratches, the glass will be weak-
ened and must be replaced to prevent the
possibility of the panel shattering. Contact
your local Repair agent who will be pleased
to advise further.
Contact your local Repair agent who will
be pleased to advise further.
If necessary, it is possible to reverse the oven
door. This operation should be carried out by
authorized personnel authorized personnel authorized personnel ONLY. authorized personnel authorized personnel
Customers are recommended not to
carry out this operation themselves.
ATAG supplies a range of cleaning agents
under the name of ATAG Shine.
You may order these on www.hps.nl. This
site also contains several tips on cleaning
and operating the appliance.

Replacing the oven light

Disconnect the appliance
If the oven bulb needs replacing, it must comply
with the following specifications:
- Electric power: 25 W,
- Electric rate: 230 V (50 Hz),
- Resistant to temperatures of 300°C,
- Connection type: E14.
These bulbs are available from your local Service
Force Centre.
To replace the faulty bulb:
1. Ensure the oven is isolated from the electrical
supply.
2. Push in and turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace with the
new one.
4. Refit the glass cover and restore the electrical
supply.
ATAG 81