Error Code; The "Recipe Selection" Function - Atag OX6211P Bedienungsanleitung

The "Recipe Selection" Function

Fig. 23
pork (2 kg)
64 ATAG
1. If the oven is on, switch it off by pressing the
"ON/OFF" button.
2. Press "MENU" button and turn clockwise
TEMPERATURE/TIME knob at the same time for
about 3 seconds The Electronic Control beeps
once.

Error Code

The Oven Electronic Control does a continuous
diagnostic check of the system. If some
parameters are not correct, the control unit will
stop the activated
corresponding error code will be displayed.
For further details, refer to chapter "Something
not Working".
Some recipes have been stored into the Oven
Electronic Control memory to allow you to cook
fourteen different dishes using pre-set cooking
functions, temperatures and cooking times.
The available recipes are listed in the table below.
To choose a recipe:
1. Press the "ON/OFF" button to switch on the
oven;
2. Press the "MENU" button : the upper section
of the display will show the name of the recipe,
and symbol will come on near the "Cooking
Duration" symbol
duration is already set in the memory. The lower
section will show the symbol of the pre-set cooking
function and the pre-set cooking temperature.
It is not possible to change the pre-setted It is not possible to change the pre-setted It is not possible to change the pre-setted
It is not possible to change the pre-setted It is not possible to change the pre-setted
temperature. temperature. temperature.
temperature. temperature.
Symbol " " will flash at the right hand of the
temperature display. (Fig. 23);
3. When 5 seconds elapse, symbol "
disappears and the thermometer symbol rises
slowly , indicating the degree to which the oven
is currently heated. The upper section of the
display will now show the cooking duration at the
functions
. This means that a cooking
and the
"