Demo Mode - Atag OX6211P Bedienungsanleitung

Fig. 20
Fig. 21
Fig. 22
"Demo" mode
This mode is intended to be used in the shops to
demonstrate the oven functionality without any
power consumption except the oven lamp and
the fan. This function can only be switched on
when the appliance is first connected or when
the power supply is restored again after a power
failure.
It is possible to activate the demo function while
the symbol flashes next to the "Clock Symbol"
.Then, proceed as follows:
1. Press "TIMER" button for approximately 2
seconds. A short acoustic alarm will be heard for
a short time.
2. Press "TIMER" button and turn counter
clockwise TEMPERATURE/TIME knob at the same
time for about 3 seconds. A short acoustic alarm
will be heard and the indication 12:00 will appear
in the display (Fig. 20).
When the oven is switched on the symbols
appear in the display. This means that the demo
function is activated.
All oven functions can be selected (Fig. 21).
The oven is not really working and the The oven is not really working and the
The oven is not really working and the The oven is not really working and the The oven is not really working and the
heating elements do not switch on. heating elements do not switch on.
heating elements do not switch on. heating elements do not switch on. heating elements do not switch on.
To disable the demo mode:
Switch off the oven and follow the procedure above
in reverse to switch off the demo function again.
"Beep" mode
You can choose to make The Electronic Control
beep each time that a button is pressed.
To enable this function, the oven must be off.
1. Press the "MENU" button and turn clockwise
TEMPERATURE/TIME knob at the same time for
about 3 seconds. The Electronic Control beeps
once (Fig. 22).
To disable the "Beep" Function: To disable the "Beep" Function: To disable the "Beep" Function: To disable the "Beep" Function: To disable the "Beep" Function:
and
ATAG 63