Closing The Door - Küppersbusch IKE3180-3 Benutzerinformation

44
Problem
Water flows inside the refrig-
erator.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
All the temperature setting
LEDs flash at the same time.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
Possible cause
The water outlet is clog-
ged.
Food products prevent that
water flows into the water
collector.
The FastFreeze or Intensi-
veCooling function is
switched on.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The FastFreeze function is
switched on.
There is no cold air circula-
tion in the appliance.
An error has occurred in
measuring the tempera-
ture.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Authorised
Service Centre.
Solution
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Switch off FastFreeze or Inten-
siveCooling manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FastFreeze or In-
tensiveCooling function".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room temper-
ature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Refer to "FastFreeze function".
Make sure that there is cold air
circulation in the appliance.
Contact the nearest Authorised
Service Centre. The cooling
system will continue to keep
food products cold, but tem-
perature adjustment will not be
possible.