Replacing The Lamp; Closing The Door - Küppersbusch FKF4800.0i Bedienungsanweisung Mit Montageanweisungen

12
Problem
The compressor does not
start immediately after
pressing the "Shopping", or
after changing the tempera‐
ture.
Water flows inside the refrig‐
erator.
Temperature cannot be set.
dEMo appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.

Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Possible cause
This is normal, no error
has occurred.
Food products prevent the
water to flow into the wa‐
ter collector.
The "Shopping function" is
switched on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The "Shopping function" is
switched on.
There is no cold air circu‐
lation in the appliance.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
Solution
The compressor starts after a
period of time.
Make sure that food products
do not touch the rear plate.
Switch off "Shopping function"
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "Shopping function".
Keep the OK pressed for ap‐
proximately 10 seconds until a
long sound is heard and dis‐
play shuts off for a short time.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Add less food products at the
same time.
Open the door only if necessa‐
ry.
Refer to "Shopping function".
Make sure that there is cold
air circulation in the appliance.