IGNIS ADL 456/1 A+ Gebrauchsanweisung Seite 63

Noise
Problem Possible causes
Beating in the wash tub A spray arm is hitting against an
item in the rack.
Shaking in the wash tub The dishes are not placed firmly in
the wash tub.
Beating in the water This can be caused by the
pipes installation in the place or by the
pipe section.
Unsatisfactory wash results
Problem Possible causes
The dishes are not clean The dishes were not loaded
properly.
The program is not intensive
enough.
Not enough detergent was
dispensed.
Dishes block the spray arms.
The filter assembly on the bottom
of the wash tub is not clean or not
fitted properly. This can cause
clogging of the spray arm nozzles.
Streaks on glasses Combination of soft water and too
much detergent.
Black or gray marks on Aluminum utensils have rubbed
dishes against dishes.
Detergent residuals in The dishes block the detergent
the dispenser dispenser.
What to do
Stop the program, rearrange the items blocking the spray arm.
Stop the program and rearrange the dishes.
This does not affect dishwasher operation; in case of doubt, contact a
qualified plumber.
What to do
See the notes in the section "Loading dishwasher racks".
Select a more intensive program.
See "Table of wash cycles".
Use more detergent, or change the type of detergent.
Rearrange the items so that the arms can rotate freely.
Clean and/or properly fit the filter assembly. Clean the spray arm nozzles.
See the section "Cleaning the spray arms".
Use less detergent if the water is soft and select a shorter cycle for the
glasses to make them clean.
Use a mildly abrasive detergent to remove the marks.
Reload the dishes properly.
63