Cleaning The Spray Arms - IGNIS ADL 456/1 A+ Gebrauchsanweisung

Filter assembly
To obtain the best performance and results, the filter assembly must be cleaned.
The filter effectively removes food residuals from the washing water, allowing its recycling during the
cycle. To obtain best performance and results, the filter must be cleaned. Therefore, it is advisable to
remove the largest food residuals caught in the filter after every wash cycle, rinsing the semicircular filter
and cup under running water.
To remove the filter assembly, pull the cup grip upward. The entire filter assembly should be cleaned once
a week.
Use a brush to clean the coarse filter. Then reassemble the filter parts as shown in the figures and refit the
entire assembly in the dishwasher, positioning it in its place and pressing it down.
The dishwasher must never be used without the filters. Incorrect reassembly of the filter can reduce
appliance performance and damage dishes and utensils.
ATTENTION:
• The dishwasher must never be used without the filters.
• Incorrect reassembly of the filter can reduce appliance performance and damage dishes and utensils.

Cleaning the spray arms

The spray arms must be cleaned regularly to
remove scale caused by hard water and to
prevent blocking of the nozzles and the spray arm
supports.
Unscrew
It is advisable to insert a needle in the clogged
nozzles of the spray arms to ensure a good wash.
Dishwasher care
The control panel can be cleaned with a damp cloth. Dry thoroughly after cleaning. To clean the exterior,
use a good wax polish.
Never use sharp objects, scouring pads or harsh detergents on any component of the dishwasher.
Frost protection
In winter take precautions to protect the dishwasher against frost. After every wash cycle, proceed as
follows:
1. Cut the dishwasher power cable.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain the water from the supply hose and the water valve. (Use a basin to collect the water)
4. Reconnect the water supply hose to the water valve.
5. Remove the filter on the bottom of the tub and use a sponge to absorb the water in the tray.
Cleaning the door
To clean the edge around the door, only use a warm and damp soft
cloth. To prevent the ingress of water in the door closure and in the
electrical components, do not use any type of spray detergent.
52