Maintenance And Cleaning; Filtering System - IGNIS ADL 456/1 A+ Gebrauchsanweisung

MAINTENANCE AND CLEANING

Filtering system

The filter prevents the entry of food residuals or other objects. The residuals can block the filter, in which
case they must be removed.
The filtering system is consists of a coarse filter, a flat filter (main filter) and a microfilter (fine filter).
1. Main filter
Food residuals and dirt retained by this filter are pulveri-
zed by a special jet of the lower spray arm and then run
to the drain channel.
2. Coarse filter
The largest residuals, such as pieces of bone or glass,
that could clog the drain are caught in the coarse filter.
To remove the residuals retained in this filter, gently
press the lid on the top of the filter and remove it.
3. Fine filter
This filter retains the dirt and food residuals in the tray
and prevents them from being deposited on the dishes
during a cycle.
- After every wash, inspect the filters to make sure they are not clogged.
- The filtering system can be removed by unscrewing the coarse filter. Remove the food residuals and
clean the filters under running water
Step 1: turn the filter counterclockwise and pull it out.
Step 2: lift the main filter
Step 3: lift the fine filter
NOTE
To remove the filter, carry out steps 1 to 3; carry out the steps in reverse order, from 3 to 1, to install it.
2
1
3
1
2
3
51
Open