IGNIS ADL 456/1 A+ Gebrauchsanweisung Seite 60

ATTENTION:
Incorrect connection of the ground wire can result in electric shock. In case of doubt regarding correct
grounding of the appliance, contact a qualified electrician or an After-Sales Service technician. Do not
modify the plug supplied with the appliance; if it is unsuitable for the socket, have a suitable one installed
by a qualified electrician.
ATTENTION:
To avoid stagnation of water in the supply hose, turn off the water tap after use. (For models without
safety supply hose).
Cold water connection
The appliance must be connected to the water supply with new hoses, and the
old ones must not be reused.
The water pressure must be between 0.04 MPa and 1 MPa. If the pressure
drops below the minimum, contact our After-Sales Service Department.
1. Pull out the safety filling hoses from the compartment located in the back
of the dishwasher.
2. Tighten the screws of the safety filling hose on the tap with ¾" thread.
3. Before starting the dishwasher, turn the water supply on fully.
Safety filling hose
The safety filling hose has double walls. The safety system stops the flow of water in case of breakage of
the inlet pipe or water filling the cavity between the inlet pipe and the external corrugated pipe.
ATTENTION:
If a hose connected to a spray device in the sink is installed on the same water line of the dishwasher,
there is risk of bursting. If the sink is equipped with a device of this type, it is advisable to disconnect the
hose and insert the plug in the hole.
Disconnecting the safety filling hose
1. Turn off the water tap.
2. Reduce the water pressure by pressing the pressure relief button. A lower pressure will protect you
and the entire room from any strong sprays.
3. Unscrew the safety inlet pipe from the tap.
Cold water connection
Connect the cold water supply hose to a 3/4" threaded connector, making sure it is tight.
If the water pipes are new or have not been used for a long time, let the water run and make sure it
becomes clear and free of impurities. Without this precaution, the water entry point could become
clogged, damaging the appliance.
Hot water connection
The water system supplying the appliance can also be connected to the domestic hot water piping
(centralized system, heating system), provided a temperature of 60°C is not exceeded. In this case, the
wash cycle time will be shorter by about 15 minutes and washing efficiency slightly less.
Connection to the hot water piping must be carried out following the same procedures described for the
connection to the cold water.
60