IGNIS ADL 456/1 A+ Gebrauchsanweisung Seite 39

B. Loading salt in the water softener
Always use dishwasher salt.
The salt container is located under the bottom rack and must be filled as explained below.
Attention!
• Only use dishwasher salt! All other types of salt not specific for dishwashers, and especially table salt,
will damage the water softener. The manufacturer provides no guarantee for any damage caused by the
use of unsuitable salt.
• Fill with salt only before starting one of the complete wash programs. This will prevent any grains of
salt or spilled salt water from remaining on the bottom of the machine and eventually causing
corrosion.
Open
A. Remove the bottom rack, then unscrew and remove the cap from salt container. (1)
B. Before the first wash, pour one liter of water into the salt container.
C. Put the end of the funnel (supplied) in the hole and add about 1 kg of salt. A small amount of water
may come out of the container; this is quite normal. (2).
D. After filling the container, tighten the cap counterclockwise.
E. The salt indicator usually goes off 2-6 days after filling the container.
F. Immediately after filling the salt container it is necessary to start a wash program (we recommend using
a soak program or a quick program). Otherwise the filtering system, pump or other important
components of the machine can be damaged by the salt water. This type of damage is not covered by
warranty.
Note:
1. The salt container must be refilled only when the indicator on the control panel lights up.
If the salt does not dissolve properly, the salt indicator may remain lit even after filling the container.
If the control panel does not have an indicator light (on some models), it is possible to estimate when
to load salt in the water softener according to the cycles done by the dishwasher.
2. If salt comes out, start a soak program or a quick program to remove the excess salt.
1
39
2