IGNIS ADL 456/1 A+ Gebrauchsanweisung Seite 58

Dishwasher installation
1. Fit the cabinet door on the outer side of the dishwasher door using the brackets supplied. Use the
template for positioning of the brackets.
2. Adjust the tension of the door springs with an Allen key, turning it clockwise to tighten the springs on
the right and left. If the tension is not adjusted the dishwasher could become damaged (figure 2).
3. Connect the supply hose to the cold water pipe.
4. Connect the drain hose. See the diagram (figure 6)
5. Connect the power cabled.
6. Fix the anti-condensation strip under the cabinet worktop. Make sure the anti-condensation strip is
flush with the edge of the worktop.
7. Position the dishwasher.
8. Level the dishwasher. The rear feet can be adjusted from the front of the dishwasher by turning the
screws on the left and right sides of the cabinet (figure 5A). To adjust the front feet, use a wrench and
turn the front feet until the dishwasher is level (figure 5B).
9. The dishwasher must be securely positioned. This can be done in two ways:
A. Normal worktop - Fix to the worktop with two wood screws, making sure the dishwasher does
not strike the surface (figure 6).
B. Marble or granite worktop - Fix the bracket on the side panel of the dishwasher and fix the dishwa-
sher to the cabinet. Fit the rubber cap on the screw (figure 7).
Screw
Bevel gear
Figure 7
Rubber
cap
Screw
58