Troubleshooting & Tips - IGNIS ADL 456/1 A+ Gebrauchsanweisung

TROUBLESHOOTING TIPS
Before calling the After-Sales Service
By checking the following troubleshooting guide, you may not need to call the After-Sales Service
Technical problems
Problem Possible causes
The dishwasher does Blown fuse or tripped switch
not start
The power is not turned on
Error code: El; the water pressure
is low
The dishwasher door is not closed
properly
The dishwasher does Bend in the drain hose
not drain the water
Clogged filter
Kitchen sink clogged
General problems
Problem Possible causes
Foam in the tub Unsuitable detergent.
Spilling of rinse aid.
Inside of tub stained Detergent with dyes used.
White film on the inner Minerals in hard water.
surface
Rust stains on cutlery The stained items are not corrosion
resistant.
A program was not started after
the addition of salt. Traces of salt in
the wash cycle.
The water softener lid is not closed
properly.
What to do
Replace the fuse or reset the switch. Remove any other appliance
connected to the same circuit as the dishwashe.
Make sure the dishwasher is switched on and that the door is properly
closed.
Make sure the power cable is plugged into the wall socket.
Check that the water supply hose is properly connected and that the
water tap is turned on.
Make sure the door closes properly and secure it.
Check the drain hose.
Check the filter (see the section "Cleaning the filter").
Check the sink to make sure it drains properly. If the problem is the
kitchen sink that does not drain, you may need a plumber instead of a
technician for the dishwasher.
What to do
Only use detergents specific for dishwashers. In case of excess of foam,
open the dishwasher and let it evaporate. Pour 4 liters of cold water into
the tub. Close and secure the dishwasher, then start the "soak" cycle to
drain the water. Repeat if necessary.
Any spilled rinse aid must be immediately removed with a cloth.
Make sure the detergent is without dyes.
To clean the inside, use a damp sponge with dishwasher detergent and
wear rubber gloves. Never use detergents that are not specific for
dishwashers: risk of foaming.
–
Always start a quick wash program without dishes in the machine and
without selecting the "Turbo" function (if available), after adding the salt.
Check the lid. Make sure it is well sealed.
62