IGNIS ADL 456/1 A+ Gebrauchsanweisung Seite 50

Switching the appliance on
Starting a wash cycle
1. Pull out the top and bottom racks, load the dishes and reinsert the racks.
It is advisable to load the bottom rack first, then the top one (see the section "Loading the dishwa-
sher").
2. Add the detergent (see the section "Salt, detergent and rinse aid").
3. Insert the plug in the power socket. The power supply is 220-240 VAC /50 HZ, the socket is 10A 250
VAC. Make sure the water supply is at full pressure.
4. Close the door, press the ON/OFF button, the ON/OFF indicator lights up. Press the program button
to select the desired wash cycle. Close the door. After 3 seconds, the machine starts.
Modification of program...
Premise:
1. A current cycle can be modified only if it has been running for just a short time. Otherwise, the deter-
gent may have already been dispensed and the appliance may have already drained the wash water. In
this case, the detergent dispenser must be refilled (see the section "Loading the detergent").
2. Press the program button for more than 3 seconds to cancel the program and the program can then
be modified, setting the desired one (see the section "Starting a wash cycle...").
3. Press one of the other program buttons for more than 3 seconds to cancel the current program and
select the program corresponding to the pressed button.
4. Press the display button for more than 3 seconds to modify the time shown.
NOTE: If all the indicators light up, it means that the machine has a fault; switch off the power supply and
turn off the water tap before calling the After-Sales Service.
A dish has not been loaded?
A forgotten dish can be added at any time before the detergent dispenser is opened.
1. Open the door slightly to stop the wash.
2. When the spray arms stop, the door can be opened completely.
3. Load the forgotten dishes.
4. Close the door and the dishwasher resumes operation after 10 seconds.
ATTENTION:
It is dangerous to open the door during washing: risk of scalding by boiling water.
At the end of the wash cycle
When the wash cycle has finished, the dishwasher buzzer sounds for 8 seconds and then goes off. Switch
the appliance off by pressing the ON/OFF button, turn off the water supply and open the dishwasher
door. Wait a few minutes before unloading the dishwasher, to avoid touching the dishes and utensils when
they are still hot and more susceptible to breakage. They will dry even better.
Switching off the dishwasher
The program ends only when the dishwasher buzzer has sounded for 8 seconds.
1. Switch off the dishwasher by pressing the ON/OFF button.
2. Turn off the water tap!
Open the door carefully.
The hot dishes are sensitive to impact. The dishes must be left to cool for about 15 minutes before remo-
ving them.
Open the dishwasher door, leave it ajar and wait a few minutes before removing the dishes. In this way,
they cool and drying is better.
Unloading the dishwasher
It is normal for the dishwasher to be wet inside.
Empty the bottom rack first and then the top one. In this way water will not drip from the top rack onto
the dishes in the bottom rack.
50