IGNIS ADL 456/1 A+ Gebrauchsanweisung Seite 41

Rinse aid dispenser
1. To open the dispenser, turn the cap towards the arrow "open" (left) and
remove it.
2. Add rinse aid in the dispenser, being careful not to overfill.
3. Refit the cap, inserting it aligned with the arrow "open" and turning it
towards the arrow "closed" (right).
The rinse aid is dispensed during the final rinse to prevent drops of water
on the dishes that would leave stains and streaks. It also improves drying by
allowing the water to run off dishes. The dishwasher is designed for the use
of liquid rinse aids. The rinse aid dispenser is on the inside of the door, next
to the detergent dispenser. To fill the dispenser, open the cap and add the
rinse aid until the level indicator is completely black. The rinse aid dispenser
has a capacity of about 140 ml. Be careful not to overfill the dispenser
because it could overflow. Remove any spilled rinse aid with a damp cloth.
Remember to refit the cap before closing the dishwasher door.
Attention!
Remove any rinse aid spilled during filling with an absorbent cloth, to avoid excess foaming during the next
wash.
Rinse aid dispenser adjustment
The rinse aid dispenser has six or four settings. Always start with
the dispenser set to "4". If the dishes do not dry properly and have
stains, increase rinse aid dispensing amount by removing the cap
and turning the selector to "5". If the dishes are still not perfectly
dry or have stains, set the selector to the next highest number until
the dishes are completely clean. It is advisable
to set it to "4". (The factory setting is "4")
NOTE
Increase the dosage if there are drops of water or lime spots on the
dishes after washing. Reduce it if there are sticky whitish spots on
the dishes or a bluish film on glassware or on knife blades.
41
1
2
3
Adjustment lever
(rinse aid)