Electrical Connection - IGNIS ADL 456/1 A+ Gebrauchsanweisung

The dishwasher must be level for proper operation of the racks and to ensure best washing performance.
1. Place the level on the door and on the runner of the rack inside the tub, as illustrated, to check if the
dishwasher is level.
2. Level the dishwasher by adjusting the four feet individually.
3. When leveling the dishwasher, be careful not tip it over.
Check the
level from
front to
back
Figure 8
Illustration of feet adjustment.
NOTE: The maximum height adjustment of the feet is 60 mm.

Electrical connection

ATTENTION:
For personal safety:
• DO NOT USE EXTENSION LEADS OR ADAPTERS WITH THIS APPLIANCE.
• DO NOT CUT OR REMOVE THE POWER CABLE PLUG GROUND CONNECTION.
Electrical requirements
Check the rated voltage on the data plate and connect the dishwasher to an adequate power supply. Use a
10 amp fuse; a fuse or delay switch is recommended, and use a separate circuit just for this appliance.
ATTENTION:
Before using the appliance, make sure there is a proper ground connection
Electrical connection
Make sure the voltage and frequency match the values given on the data plate. Insert the plug only in a
grounded electrical socket. If the electrical socket the appliance is to be connected to is not suitable for
the plug, replace the socket rather than use adapters or similar devices that could cause overheating and
burns
Instructions for the ground connection
This appliance must be grounded. In case of malfunction or failure, the ground connection reduces the risk
of electric shock by providing a path of least resistance for the electric current. This appliance is equipped
with a cable with ground wire and grounding plug. The plug must be inserted a suitable socket installed
and grounded in compliance with the local regulations.
Check the level from side to side
59