Inhaltsverzeichnis
Werbung
Safety regulations
Noise and vibration data
The following listed noise and vibration data according to the EC
machine directive in the version (91/368/EEC) was determined at the
rated speed of the drive motor with vibration with the machine placed on
a resilient base.
Values can deviate in normal use depending on the conditions prevail-
ing at the place of use.
1.
Noise data
The noise emission specified in appendix 1, subclause 1.7.4.fof the EC
machine directive for
the sound pressure level at the operator workplace is
LpA
=
87 dB (A)
the sound power level
LWA
=
98 dB (A)
These noise levels were measuredaccording
to ISO 3744 for the sound
power level
(LWA)
and ISO 6081 for the sound pressure level
(LpA)
at the
operator workplace.
(1)";
Since the permissible noise rating level of 89 dB (A) can be
.•.
exceeded with this machine, the operator must wear suitable
_
hearing protection.
2.
Vibration data
Hand-arm vibration values according to appendix 1, sub-clause 3.6.3.a
of the EC machine directive:
The weighted effective value of acceleration, determined according to
ISO 8662, part 1, is about 12
m/sec2•
Transporting the machine .
Only load and transport the machine as specified in the operating
instructions.
Only use suitable means of transport and lifting gear with sufficient
bearing capacity!
Attach suitable slinging means to the points of attachment provided.
Only use sturdy loading ramps with sufficient bearing capacity. The
ramp inclination must be flatter than the gradient climbing ability of the
machine.
Secure the machine to prevent is from tilting or slipping.
It is highly dangerous to walk or stand under suspended loads.
Secure the machine on transport vehicles to prevent it from rolling,
slipping and tilting ..
Starting the machine
Prior to starting
Familiarise yourself with the operating and control elements and the
mode of operation of the machine and the working environment. This
includes, e.g. obstacles in the working area, bearing capacity of the
ground and the necessary safety provisions.
Use personal protective equipment (safety footwear, hearing protectors
etc.).
Check to ensure that all safety devices are firmly in place.
00
not start the machine if instruments or control devices are faulty.
Starting
For machines with handstart, only use the safety cranks tested by the
manufacturer, and precisely follow the operating instructions
of the
engine manufacturer.
7
Werbung
Inhaltsverzeichnis
