Maintenance - Scheppach 5905112902 Originalbetriebsanleitung

When returning the motor always send in the complete
drive unit with switches.
Follow the safety instructions!

12. Maintenance

m Warning: Switch off the machine and disconnect
the plug before performing maintenance and adjust-
ment work.
Keep the instructions with the machine.
Keep the machine clean.
Wear safety goggles when cleaning.
Cleaning:
Caution: Do not clean the plastic parts of the table
with aggressive cleaning agents. A mild rinsing liquid
on a damp cloth is recommended. No water must come
into contact with the machine.
• Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. Rub the
product clean with a clean cloth or blow it off with
compressed air at low pressure.
• We recommend that you clean the product directly
after every use.
• Clean the product at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the product. Make sure that no water can
penetrate the interior of the product. Water penetra-
tion increases the risk of an electric shock.
Maintenance:
• Check the saw blade at regular intervals. Use only
saw blades that are well sharpened, free of cracks
and not deformed. Only use tools that comply with
the European standard DIN EN 847-1.
• Replace worn swivel frame inserts immediately.
• Check all safety devices after all maintenance or
cleaning work.
• Check that no tools or miscellaneous parts are on or
in the machine before putting it back into operation.
• Remove any sawdust accumulations that may arise
at the discharge.
After repairs or maintenance, make sure that all safe-
ty-related parts are installed and are in perfect con-
dition. All parts which may cause injury must be kept
where they are inaccessible to children or others.
32 | GB
Attention: According to the German Product Liability
Act, no liability is accepted for damage caused by im-
proper repairs or by not using original spare parts.
Such work should be performed by a customer service
centre or an authorised specialist. The same applies to
accessory parts.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*: Saw blade, swivel frame insert
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
Saw blade replacement (Fig. 11-15)
m Pull out the mains plug before changing the saw
blade.
m Danger of cutting! The saw blade is heavy and can
be slippery.
Wear gloves when changing the saw blade.
• Do not use saw blades made of HSS steel.
• Do not use cracked saw blades or blades that have
changed shape.
• Only use good, sharp saw blades.
m Danger of burns! The saw blade is still hot shortly
after sawing.
1. Hold the swivel frame firmly and pull out the spring
cotter pin (Fig. 11, A).
2. Loosen the hexagon nut (Fig. 12 B), continue to hold
the swivel frame firmly and pull the swivel frame
guide (Fig. 12 C) off the grub screw (Fig. 12 D).
3. Slowly lower the swivel frame towards the ground.
4. Secure the saw blade against twisting with the
retaining pin (Figs. 13, 14).
5. Loosen the screw (Fig. 14, E).
6. Remove the washer (Fig. 14, F), the front saw blade
flange (Fig. 14, G) and the saw blade (Fig. 14, H).
7. Clean the saw blade flange.
www.scheppach.com