Troubleshooting; Possible Cause - Scheppach 5901407901 Originalbetriebsanleitung

15. Troubleshooting

WARNING
Always switch the machine off and remove the mains plug prior to all maintenance and cleaning work.
Fault
Saw blade without pins
loosens after switching
off the engine
Engine does not start
Saw blades brake
Saw blade oscillates, not
aligned straight

Possible cause

Saw blade clamping screw (28/29) not
tightened enough
Mains fuse blown
Extension lead defective
Fine-wire fuse defective
Connection to the engine or switch not OK
Engine or switch faulty
Tension set incorrectly
Load too high
Incorrect saw blade type
Workpiece not fed straight
Holders not aligned
www.scheppach.com
Remedy
Fully tighten the saw blade clamping
screw (28/29)
Check mains fuse
Replace the extension lead
Check the fine-wire fuse and, if
necessary, replace it with a fine-wire
fuse of the same type
Have this checked by an electrician
Have this checked by an electrician
Set correct tension
Feed workpiece more slowly
Use correct saw blades
Avoid lateral pressure
Open the screws that fasten the
holders. Bring the holders into the
vertical position and tighten the screws
again.
GB | 37