Introduction; Device Description (Fig. 1 - 16); Scope Of Delivery - Scheppach 5901407901 Originalbetriebsanleitung

1.

Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling,
• Non-compliance with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists,
• Installing and replacing non-original spare parts,
• Application other than specified,
• Failures of the electrical system due to failure to
observe the national electrical requirements and
regulations.
Note:
Read the whole text of the operating manual before as-
sembly and commissioning.
This operating manual should help you to familiarise your-
self with your device and to use it for its intended purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must be
read and carefully observed by all operating personnel
before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards. The required
minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
26 | GB
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.

2. Device description (Fig. 1 - 16)

1. Blow-off device
2. Mounting (blow-off device)
3. Knurled screw
4. Holder (saw blade guard)
5. Saw blade guard
6. Saw table
7. Foot pedal
8. Cover, left
9. Storage box
10. Bearing points
11. Tightening lever
12. Boom
13. Graduated scale
14. Locking lever
15. Suction connection
16. On/off switch
17. Operating mode selection switch
18. Speed regulator
19. Assembly points
20. Work lamp
21. ON / OFF switch work lamp
22. Saw blade
23. Allen key, 3 mm
24. Depressor
25. Screw (depressor)
26. Table inlay
27. Top saw blade holder
28. Upper saw blade clamping screw
29. Lower saw blade clamping screw
30. Bottom saw blade holder
31. Angle bracket (not included in the scope of delivery)
32. Screw (graduated scale)
33. Pointer
34. Screw (left cover)
35. Screw (left cover)
36. Fine-wire fuse
37. Adjustment screw with locknut

3. Scope of delivery

• Scroll saw
• Saw blade guard (5) with depressor (24)
• Blow-off device (1)
• Saw blade (22) for wood and plastics (4x)
www.scheppach.com