Residual Risks; Technical Data; Unpacking - Scheppach Hc26Si Originalbetriebsanleitung

6. Residual risks

The machine has been built according to the state-of-
the-art and the recognised technical safety require-
ments. However, individual residual risks can arise
during operation.
• Health hazard due to electrical power, with the use
of improper electrical connection cables.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "Safety In-
structions" and the "Intended Use" together with the
operating instructions as a whole are observed.
• Avoid accidental starting of the machine: the oper-
ating button may not be pressed when inserting the
plug in an outlet. Use the tool that is recommended
in this operating manual. This is how to ensure that
your machine provides optimum performance.
• Keep your hands away from the working area when
the machine is in operation.
7.

Technical data

Mains power connection
Engine output
Operating mode
Compressor speed
Pressure vessel volume
Operating pressure
Theo. Suction capability
Theo. Power output
Protection category
Weight
Max. installation altitude
(above sea level)
Subject to technical changes!
Noise and vibration
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB, please
wear suitable hearing protection.
24 | GB
Noise data
The noise emission values have been determined in
accordance with EN ISO 3744:1995.
Note: The total vibration emission values specified
and the device emissions values specified have been
measured in accordance with a standardised test pro-
cedure and can be used for comparison of one electric
tool with another.
Note: The total vibration emission values specified and
the device emissions values specified can also be used
for an initial estimation of the load.
Warning: The vibration values and noise emission
values can vary from the specified values during the
actual use of the power tool, depending on the type and
the manner in which the power tool is used, and in par-
ticular the type of workpiece being processed.
230 V~ 50Hz
Warning: It is necessary to determine the safety
1100 W
measures for the protection of the operator based on
an assessment of the vibration load during the actual
S1
conditions of use (In doing so, all parts of the operat-
2,850 rpm
ing cycle must be taken into account such as times in
approx. 24 l
which the power tool is switched off or times in which it
is switched on, but is not running under a load).
approx. 8 bar
approx. 230 l/min

8. Unpacking

approx. 100 l/min
• Open the packaging and carefully remove the prod-
IP 30
approx. 18.2 kg
• Remove the packaging material, as well as the pack-
1000 m
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
• If possible, keep the packaging until the expiry of the
• Familiarise yourself with the product by means of the
• With accessories as well as wearing parts and re-
www.scheppach.com
Sound power level L
WA
Sound pressure level L
pA
Uncertainty K
wa/pA
uct.
aging and transport safety devices (if present).
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
warranty period.
operating manual before using for the first time.
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
85 dB
66 dB
3 dB