15.1
Ordering spare parts
Please provide the following information when ordering
spare parts:
• Model designation
• Item number
• Type plate data
15.2
Service information
With this product, it is necessary to note that the following
parts are subject to natural or usage-related wear, or that
the following parts are required as consumables.
Wearing parts*: Spark plug, air filter
* = may not be included in the scope of delivery!
17 Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your product failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
The product cannot be started
The product starts up and then immedi-
ately shuts down.
Engine runs unsteadily
Smoke is produced
Product does not work at full power
16 Disposal and recycling
Notes for packaging
You can find out how to dispose of the disused
device from your local authority or city
administration.
Fuels and oils
• Before disposing of the product, the fuel tank and the
• Fuel and engine oil do not belong in household waste
• Empty oil and fuel tanks must be disposed of in an en-
Possible cause
Air filter dirty.
Missing fuel supply.
Fault in the fuel line.
Contaminated spark plug that is too
wet due to excess fuel.
Spark plug connector not plugged in.
No ignition spark.
Engine defective.
Carburettor defective.
Incorrect
carburettor
speed).
Incorrect carburettor setting.
Air filter dirty
Spark plug dirty
Incorrect fuel mixture.
Incorrect carburettor setting.
Air filter dirty.
Spark plug dirty
Incorrect carburettor setting.
www.scheppach.com
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
engine oil tank must be emptied!
or drains, but must be collected or disposed of sepa-
rately!
vironmentally friendly manner.
Remedy
Clean/replace the air filter.
Check that there is sufficient fuel in the
tank and refuel if necessary.
Check the fuel line for kinks or dam-
age.
Remove spark plug, clean and dry;
then pull the starter cable several
times; reinsert the spark plug.
Check that the spark plug connector is
properly seated.
Check that the spark plug connector is
properly seated.
Check the spark plug for dirt and the
correct electrode gap.
Check ignition cable for damage.
Contact the service point.
Contact the service point.
Contact the service point.
setting
(idle
Setting the idling speed
Contact the service point.
Setting the idling speed
Contact the service point.
Clean or replace the air filter.
Clean or replace the spark plug.
Use two-stroke mixture with the mixing
ratio of 40:1.
Contact the service point.
Clean or replace the air filter.
Clean or replace the spark plug.
Contact the service point.
GB | 33