Setting The Material Volume; Maintenance; Operating The Air Paint Spray Gun; Preparing The Surface - Parkside PDLS 5 A1 Originalbetriebsanleitung

Switching on:
WARNING!
► The air vent on the suction cup mount and
must always be free .
► Always stop work immediately if compressed
air or spray material is discharged from
the air vent . Eliminate the cause before
continuing work .
► If you want to work in a position in which the
suction cup is being held at an angle, only
fill it half full . This ensures that no spray
material can get into the air vent
♦ To switch on, pull the trigger on the air spray
gun and keep it pressed in .
Switching off:
♦ To stop working, simply release the trigger on
the air spray gun

Setting the material volume

You can regulate the material quantity which is
sprayed .
♦ Undo the lock nut
♦ Turn the nozzle
♦ Fix the nozzle in place with the lock nut

Maintenance

WARNING! RISK OF INJURY! Discon-
nect the tool from the compressed air
supply.
♦ Clean the appliance after every use .
WARNING – PROPERTY DAMAGE!
► Never submerse the appliance completely in
cleansing agents, otherwise the seals can be
damaged .
♦ Rinse the air spray gun out using a container
filled with a suitable cleansing agent at low
pressure .
♦ Collect the liquid in a container and dispose of
the liquid in an environmentally correct manner .
♦ Oil the moving parts on the trigger of the air
spray gun .
PDLS 5 A1
.
.
.
into the required position .
Operating the air paint spray
gun

Preparing the surface

♦ Carefully cover a large area around the spray
surface . Any surface that is not masked could
become contaminated .
♦ Ensure that the surface is clean, dry and free of
grease .
♦ Polished surfaces should be lightly sanded and
the sanding dust removed .
Switching the air paint spray gun on
and off
Working methods:
♦ When thinning, ensure that the spray material
and the thinners are suitable for each other .
Using an unsuitable thinner can lead to the
formation of lumps which, in turn, can block the
air paint spray gun .
♦ Unscrew the lid
cup .
♦ Fill the aluminium suction cup
material .
.
♦ Screw the lid
suction cup
♦ With the aid of the fixing nut,
minium suction cup
spray gun in an anticlockwise direction .
♦ Hold the air paint spray gun at a constant
distance from the object . The ideal spraying
distance is approx . 15 cm .
♦ Work out the best settings by carrying out a
test .
♦ Do not switch the appliance on/off over the
spray surface, rather start/end the spraying
process approx . 10 cm from the spray surface .
from the aluminium suction
with the spray
back on to the aluminium
.
screw the alu-
tightly onto the air paint
GB │ IE │ 19 ■