Setting The Paint Jet Pattern; Adjusting The Paint Flow; Adjusting The Airflow; Maintenance And Cleaning - Parkside PDFP 500 C3 Originalbetriebsanleitung

Setting the paint jet pattern

The appliance has two settings: round jet and
broad jet.
Round jet
Setting the round jet
■ Use the round jet for small surfaces, corners
and edges.
♦ Turn the control
Setting the broad jet
■ You can use the broad jet vertically or horizon-
tally for larger surfaces.
♦ Turn the control
The nozzle head
position between the horizontal and the vertical.
Adjusting the paint flow
NOTE
► The front locking bolt is designed to limit
the adjustment range of the stroke limiter
screw .
Increasing the paint flow
♦ Turn the stroke limiter screw
Decreasing the paint flow
♦ Turn the stroke limiter screw
│ GB │ MT
■ 36
Broad jet
clockwise .
anticlockwise .
can be turned into any
anticlockwise.
clockwise.
Adjusting the airflow
NOTE
► We recommend starting with the airflow set
to maximum. To do this, open the airflow
regulator to maximum as described below
in the section "Increasing the airflow".
Increasing the airflow
NOTE
► Increasing the airflow is generally advisable
if the dispersion is too coarse.
♦ Turn the airflow control
Decreasing the airflow
NOTE
► Decreasing the airflow is generally advisable
if the paint mist is too strong.
♦ Turn the airflow control

Maintenance and cleaning

WARNING! RISK OF INJURY!
Disconnect the appliance from the
compressed air supply.
NOTE
► Thorough cleaning after every use is very
important for safety and operation. Other-
wise, the needle could get blocked and
proper operation of the appliance cannot
be guaranteed.
■ Wear suitable gloves when cleaning.
■ Do not use any hydrocarbon-based solvents like
benzene, ethyl chloride, etc., as these could
trigger chemical reactions with some of the
materials in the paint spray gun. This can lead
to dangerous reactions.
CAUTION!
► Never immerse the paint spray gun com-
pletely in solvent.
anticlockwise.
clockwise.
PDFP 500 C3