Sata Configuration - Beckhoff CB1064 Series Handbuch

Advanced

4.3.9 SATA Configuration

Aptio Setup Utility - Copyright (C) 2016 American Megatrends, Inc.
Advanced
┌─────────────────────────────────────────────────────────────────┬────────────────────────────────┐
│ SATA Controller(s)
│ SATA Mode Selection
│ CR#1 - RST Pcie Storage Remapping
│ CR#1 - Remap Port Selection
│ CR#2 - RST Pcie Storage Remapping
│ CR#2 - Remap Port Selection
│ CR#3 - RST Pcie Storage Remapping
│ CR#3 - Remap Port Selection
│ SATA Test Mode
│ Alternate ID
│► Software Feature Mask Configuration
│ Aggressive LPM Support
│ SATA Controller Speed
│
│ Serial ATA Port 0
│ Software Preserve
│ Port 0
│ Hot Plug
│ Mechanical Presence Switch
│ External SATA
│ Spin Up Device
│ SATA Device Type
│ Topology
│ Device Sleep
│ SATA DEVSLEP Idle Timeout Config
│
│
└─────────────────────────────────────────────────────────────────┴────────────────────────────────┘
Version 2.18.1259. Copyright (C) 2016 American Megatrends, Inc.
 SATA Controller(s)
Optionen: Enabled / Disabled
 SATA Mode Selection
Optionen: IDE / AHCI / RAID
 CR# 1 - RST Pcie Storage Remapping
Optionen: Enabled / Disabled
 CR# 1 - Remap Port Selection
Optionen: Auto / Port 9 / Port 10 / Port 11 / Port 12
 CR# 2 - RST Pcie Storage Remapping
Optionen: Enabled / Disabled
 CR# 2 - Remap Port Selection
Optionen: Auto / Port 13 / Port 14 / Port 15 / Port 16
 CR# 3 - RST Pcie Storage Remapping
Optionen: Enabled / Disabled
 CR# 3 - Remap Port Selection
Optionen: Auto / Port 17 / Port 18 / Port 19 / Port 20
 SATA Test Mode
Optionen: Enabled / Disabled
 Alternate ID
Optionen: Enabled / Disabled
 Software Feature Mask Configuration
Untermenü: siehe "Software Feature Mask Configuration" (Seite 81)
Beckhoff New Automation Technology CB1064-xxxx
[Enabled]
[RAID]
[Enabled]
[Auto]
[Enabled]
[Auto]
[Enabled]
[Auto]
[Disabled]
[Disabled]
[Enabled]
[Default]
Empty
Unknown
[Enabled]
[Enabled]]
[Enabled]
[Disabled]
[Disabled]
[Hard Disk Drive]
[Unknown]
[Disabled]
[Disabled]
Kapitel: BIOS-Einstellungen
▲│Enable or disable SATA Device.
█│
█│
█│
█│
█│
█│
█│
█│
█│
█│
█│
█│────────────────────────────────│
░│→←: Select Screen
░│↑↓: Select Item n
░│Enter: Select
░│+/-: Change Opt.
░│F1: General Help
░│F2: Previous Values
░│F3: Optimized Defaults
░│F4: Save & Exit
░│ESC: Exit
░│
░│
░│
░│
▼│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
Seite 79