Herunterladen Inhalt Inhalt Diese Seite drucken

Symbols On The Machine; Proper Use - Kärcher HDS 801 B Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für HDS 801 B:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
25 Temperature controller
26 Connection for water supply with filter
27 High pressure hose
28 High pressure connection
29 Strut for crane loading *
* Additional accessory

Symbols on the machine

High-pressure jets can be dan-
gerous if improperly used. The
jet may not be directed at persons, animals,
live electrical equipment or at the appliance
itself.
According to applicable regula-
tions, the appliance must never be
used on the drinking water net
without a system separator. En-
sure that the connection of your building
water installation on which the high-pres-
sure cleaner is operated is equipped with a
system separator pursuant to EN 12729
Type BA.
Water that was flowing through a system
separator is considered non-drinkable.
CAUTION
Always connect the system separator to
the water supply, never directly to the appli-
ance!
Risk of poisoning! Do not
breathe in the exhaust fumes.
Risk of burns on account of hot
surfaces!

Proper use

Note: Applicable only for Germany: The
appliance is meant only for mobile (non-
stationary) operations.
The appliance is used especially at loca-
tions where there is no electrical connec-
tion and it is necessary to work with hot wa-
ter.
Cleaning of: Machines, Vehicles, Struc-
tures, Tools, Facades, Terraces, Garden-
ing tools, etc.
16
– Use only the high pressure jet without
detergent for cleaning facades, terrac-
es, garden equipment, etc.
– For stubborn dirt, we recommend the
use of the dirt blaster as a special ac-
cessory.
DANGER
Risk of injury! Follow the respective safety
regulations upon employment at gas sta-
tions or other dangerous areas.
Please do not let mineral oil contaminated
waste water reach soil, water or the sew-
age system. Perform engine cleaning and
bottom cleaning therefore only on speci-
fied places with an oil trap.
Quality requirements for water:
ATTENTION
Only clean water may be used as high
pressure medium. Impurities will lead to in-
creased wear and tear or formation of de-
posits in the appliance.
If recycled water is used, the following limit
values must not be exceeded.
pH value
electrical conductivity *
settleable solids **
total suspended solids *** < 50 mg/l
Hydrocarbons
Chloride
Sulphate
Calcium
Total hardness
Iron
Manganese
Copper
Active chloride
free of bad odours
* Maximum total 2000 μS/cm
** Test volume 1 l, settling time 30 min
*** no abrasive substances
– 2
EN
6,5...9,5
Conductivity
fresh water
+1200 μS/cm
< 0,5 mg/l
< 20 mg/l
< 300 mg/l
< 240 mg/l
< 200 mg/l
< 28 °dH
< 50 °TH
< 500 ppm (mg
CaCO
/l)
3
< 0,5 mg/l
< 0,05 mg/l
< 2 mg/l
< 0,3 mg/l

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis