Frost Protection; Storage; Transport; Care And Maintenance - Kärcher HDS 801 B Originalbetriebsanleitung

ATTENTION
Never stop the motor under full load when
the hand-spray gun is opened.
 Set thermostat to "Burner off" position.
 Rinse the device thoroughly for at least
30 seconds.
 Release the lever on the trigger gun.
Motor regulates to reach dry run speed.
 Set the key switch at the motor to
"OFF".
 Close fuel cock.
 Shut off water supply.
 Activate hand spray gun until device is
pressure less.
 Secure the hand spray gun using the
safety catch so that it doesn't open ac-
cidentally.
 Remove the water inlet hose from the
appliance.

Frost protection

ATTENTION
Risk of damage! Freezing water in the ap-
pliance can destroy parts of the appliance.
 Store the appliance in a heated room
during winter or empty it. During longer
breaks in operation, it is advisable to
pump in anti-frost agents into the appli-
ance.

Storage

CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.

Transport

CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Release parking brake.
 Push the appliance.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.

Care and maintenance

You can sign with your dealer a contract for
regular safety inspection or even sign a
maintenance contract. Please take advice
on this matter.
DANGER
Risk of injury if the machine is left running
in an unattended state. Shut off the fuel
supply before doing any work on the appli-
ance.
Risk of burns! Do not touch hot silencers,
cylinders or radiator ribs.

Maintenance intervals

Weekly
 Clean the sieve in the water connection.
 Check oil level of the high pressure
pump.
ATTENTION
In case of lacteous oil inform Kärcher cus-
tomer service immediately
Half-yearly
 Booster heater: Dismantle burner inlay;
clean burner and ignition electrodes;
check distance between electrodes; ad-
just if required or replace ignition elec-
trodes.
Half-yearly or when required
 Empty and clean the fuel tank.
 Clean the filter in front of the fuel pump
and fuel nozzle.
 Desulphurise the heating coil and re-
move soot from it.
 Change the oil in the high pressure
pump.
Every 500 operating hours, at least
annually.
 Have the maintenance of the device
performed by the customer service.
– 7
EN 21