Control LEDs on the charger
Green
Red
Lights
—
up
—
Lights
up
—
Flashes
Flashes
Flashes
Re
ing/inser ing he
battery pack
CAUTION! Risk of injury due to
m
unin en i nal s ar -u
Only insert the battery pack once
u
the product is fully ready for use.
NOTICE! Risk of property and
m
product damage!
Only use the product with a battery
u
pack of the X 20 V TEAM series
from Parkside. An incorrect
battery pack can damage the
product and the battery pack.
(Fig. C)
Removing the battery pack
1. Press the release button
batter pack
9 ]
[
2. Pull the batter pack
batter pack holder
Inserting the battery pack
Push the batter pack
o
the guide rail into the battery pack
holder
. You will hear the battery
6 ]
[
pack click into place.
Meaning
Fully charged
Stand-by mode
(no battery
pack
i nserted)
[
9 ]
Charging
Batter pack
[
9 ]
is overheated
Batter pack
[
9 ]
is defective
on the
[
]
.
off the
[
9 ]
.
[
6 ]
along
[
9 ]
Operation
CAUTION! Risk of injury!
m
Always wear appropriate protective
u
equipment and work gloves while
working with the product.
Prior to each use, ensure that the
u
product is working correctly and
has been assembled properly.
Do not use the product if the on/off
u
switch is damaged.
Personal protective equipment and
u
a fully functional product reduce
the risk of injuries and accidents.
After the product has been
u
switched off, the impeller wheel
continues moving for some time.
There is a risk of injury caused by
the rotating impeller wheel.
NOTE
Observe noise protection rules and
u
other local regulations.
S i ching n/
CAUTION! Risk of injury and
m
product damage!
Before switching on the product,
u
make sure that it is not touching
any objects. Ensure secure
positioning.
Switching on: Slide the on/off
o
switch
forwards into position I.
4 ]
[
S i ching
o
switch
backwards into position O.
4 ]
[
Checking the charging level
of the battery pack
Press
next to the charging
[
]
o
level indicator
[
pack
.
[
9 ]
Slide the on/off
on the battery
]
GB/IE/NI/CY/MT
41