longer periods of time
or if you do not hold or
maintain the product
properly.
Lung damage, if you
do not wear suitable
respiratory protection.
Eye injuries if you do
not wear suitable eye
protection.
Be re rs use
Unpacking the product
1. Take the product out of the
packaging and remove all packaging
materials and plastic wrappings.
2. Check to make sure that all listed
parts are included (see "Scope of
deliver ).
3. Check whether the product and all
parts are in good condition, if any
damage or defect is detected, do
not use the product, but follow the
procedure described in chapter
"Warranty".
Preparation
Fi ing/re
pipe
CAUTION! Risk of injury!
m
Before fitting or removing the
u
blower pipe: Switch off the
product. Make sure all moving
parts have come to a standstill.
Before carrying out any work on
u
the product: Remove the battery
pack.
40 GB/IE/NI/CY/MT
ing he bl
er
(Fig. B)
Fitting the blower pipe
1. Slide the blower pipe
connection piece
button
clicks into place.
2 ]
[
2. Check that the blower pipe
secure by pulling on it.
Removing the blower pipe
1. Press and hold the release button
2. Pull the blower pipe
connection piece
Charging the battery pack
NOTICE! Risk of damage to the
m
battery pack!
Do not expose the battery pack
u
to direct sunlight for long periods
and do not place it on a radiator.
Observe an ambient temperature
of max. +50 °C.
NOTE
ou can find detailed instructions
u
in the user manual of the charger.
If the battery pack is still warm,
u
allow it to cool down before
charging.
1. Remove the batter pack
product (see "Removing/inserting the
batter pack ).
2. Push the batter pack
charging slot of the charger
3. Connect the charger
outlet.
4. After charging, disconnect the
charger
from the socket-outlet.
8 ]
[
5. Pull the batter pack
charger
.
8 ]
[
onto the
1 ]
[
until the release
[
]
is
[
1 ]
2 ]
[
off the
[
1 ]
.
[
]
from the
9 ]
[
into the
[
9 ]
.
8 ]
[
to a socket-
8 ]
[
out of the
[
9 ]
.