Charging The Battery Pack; Checking The Battery Condition; Perfectly Designed; The Ergonomics Package - Parkside PABS 18-2 SL Bedienungsanleitung

Operation

Charging the battery pack

Before inserting the battery pack into the charger or
removing it from the charger, always ensure the plug
is not in the mains socket.
Insert the battery pack so that it is firmly held in
the charger. Push the plug into the mains socket.
„ The red charging light
has begun. The red light will go out after about
1 hour.
„
The green charging light
charging is complete and the battery pack is rea-
dy for use.
If you wish to charge a second battery pack, pull
out the plug from the mains supply and keep the
charger off for at least 15 minutes. Then you can
start to charge the second battery.
Note: If you do not remove the plug from the mains
socket before the second charging process starts
then the second battery cannot be charged.
Caution!
A new battery pack is not charged and must be ful-
ly charged before first use.
Never charge the battery pack again immediate-
ly after a fast charging process has been complet-
ed. This can give rise to the battery pack being
overcharged and a reduced life of the battery and
charger.
Switch off the charger for at least 15 minutes be-
tween charges by removing the plug from the
mains socket.
If you use a multiway socket adapter, unplug all
other electrical equipment from the adapter.

Checking the battery condition

You can check the condition of the battery with the
battery in place. To do this, press the button (refer to
Fig. D) on the battery indicator
charge is displayed.
All lights on = full power / battery fully charged
16 GB
PARKSIDE
indicates that charging
lets you know when
. The remaining
Perfectly designed –

the ergonomics package

The motor housing is aligned at an angle of approx.12°
to the handle. This ensures that for typical working
and handling situations the drill is at the correct an-
gle to the workpiece surface.
work precisely and much more effectively – try it out
yourself ...
„ The particularly generously-sized controls
make it particularly quick to adjust the way the tool
works to the suit the task in hand.
„ The SOFTGRIP handle reduces vibrations and
makes working with your drill more comfortable,
refer to Fig. A.
„
The integrated hand guard is another ergonomic
feature. It protects you from injuries, e.g. when you
are drilling.
Switch speeds – the 2 gear drive
„
In first gear (switch
of up to approx. 500 rpm can be achieved. This
setting is intended for use with old screws and for
accessories.
„ In second gear (switch
speed is up to approx. 1400 rpm for drilling.
Robust and strong – the motor
The powerful motor guarantees a high torque.It works
on 18 Volts, provides a maximum torque of 18 Nm
and reaches speeds of approx. 1400 rpm. The inte-
gral electric brake ensures the tool comes to a halt
almost immediately, so that you can work more safe-
ly and quickly.
Controllable – the torque selector
Before you start screwdriving you can set the torque
selector in any of 16 torque settings to obtain the
desired torque.
In this way you can
in setting: Screw) a speed
in setting: Drill/2) the