Safety Advice Relating To Cordless Drill Drivers; Attention - Service Lines; Original Ancillaries / Accessories; Before First Use - Parkside PABS 18-Li B2 Bedienungs- Und Sicherheitshinweise

General safety advice for electrical power tools / Before first use
Safety advice relating
to cordless drill drivers
Hold the device by the
insulated handle surfaces when you
are undertaking work where there is
the danger of the screw striking hidden
electricity cables or the device's mains
lead. Contact of the screw with a live wire could
cause metal parts of the device to become live
and lead to electric shock.
Children or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited
must never be allowed to use the device without
supervision or instruction by a person responsi-
ble for their safety. Children must never be
allowed to play with the device.
Securely support the workpiece. A workpiece
held in a clamp or vice is kept more securely in
place than one held by your hand.
POISONOUS DUSTS!
Harmful / noxious dusts generated from your
work represent a risk to the health of the person
operating the device and to anyone near the
work area. Wear safety glasses and a dust mask!
Do not drill any material containing
asbestos. Asbestos is a known carcinogen.
Hold the electrical power tool firmly.
High reaction torques may occur momentarily
during tightening or loosening of screws.
If the inserted tool jams, switch off the
electrical power tool immediately. Be
prepared for high reaction torques as they may
cause kickback. The inserted tool may jam if
the electrical power tool is overloaded or is
held at an angle to the workpiece.
Before you carry out any tasks on the
device, transport or store it, make sure
that the direction of rotation switch is
in the middle position (lock). To prevent
the device from starting up unintentionally.

Attention - Service lines!

Q
DANGER! Take steps to ensure that
you do not hit upon any service lines
10 GB/CY
(electricity, gas, water) when work-
ing with electrical appliances. Check, if
need be with a service line detector, before
you start to cut or bore into a surface.
Original ancillaries /
Q
accessories
Use only the ancillaries and accessories
that are detailed in the operating
instructions. The use of ancillaries and ac-
cessories other than those recommended in the
operating instructions could lead to an increased
risk of personal injury for you.

Before first use

Q

Charging the battery pack

Q
SHOCK! Before cleaning or servicing the
charging station or the battery pack always
ensure that the plug is not in the mains socket.
Note! A new battery pack, or one that has not
been in use for an extended period, must be charged
up before the first / renewed usage.
The battery pack attains its full capacity after ca.
3–5 charging cycles.
CAUTION! Always ensure the plug is removed
from the mains socket before inserting a battery pack
into, or removing one from, the charging station.
never charge the battery pack if the ambient
temperature is less than 10 °C or greater than
40 °C.
1. Insert the battery pack
charger (see fig. C).
15
2. Insert the power plug into the socket. The flash-
ing red charge indicator LED
charging is in progress. The red charging con-
trol LED extinguishes as soon as the battery
16
pack is fully charged.
DANGER OF ELECTRIC
into the quick-
6
shows that
16