Parkside PSBSA 20-Li E4 Bedienungsanleitung Und Originalbetriebsanleitung Seite 20

˜ Operation
˜ Gear selection
Fig. E
ATTENTION! Risk of product
m
damage!
Only operate the gear selector
when the product has come to a
complete standstill.
Change the gear by sliding the gear
o
selector forwards or backwards.
[ 4 ]
1 gear:
st
Suitable for:
Speed:
Torque:
2 gear:
nd
Suitable for:
Speed:
Torque:
˜ Setting the rotating direction
Fig. F
ATTENTION! Risk of product
m
damage!
Only operate the rotation
direction switch
product has come to a complete
standstill.
Changing the direction of rotation:
o
Press the rotation direction switch
towards the left or right.
Loc ing the on off s itch
o
rotation direction switch
middle position.
18 GB/IE/NI/MT
[ 4 ]
Screwing
Low
High
Drilling
High
Low
when the
6 ] [
6 ] [
: Bring the
7 ] [
into the
[ 6 ]
˜ Tor e control/Selecting the
operating mode
Fig. G
Turn the torque preselection ring
o
the suitable position.
the desired setting:
Application
Small screws
o
Soft materials
o
Large screws
o
Hard materials
o
Removing screws
o
Drilling work
o
Hammer drilling work
o
˜ S itching on and o
Fig. F
NOTE
The on off s itch
u
locked.
Switching on
Press and hold the on off s itch
o
Regulate the speed as required (see
o
"Speed control").
S itching o
Release the on off s itch
o
˜ Speed control
You can control the speed by pressing
o
the on off s itch
degrees of force:
Pressure Speed
Gentle Low
Stronger High
to
[ 3 ]
has to point to
Setting
Low level
High level
cannot be
[ 7 ]
.
7 ] [
.
7 ] [
with varying
[ 7 ]