Parkside PSBSA 20-Li E4 Bedienungsanleitung Und Originalbetriebsanleitung Seite 19

˜ Attaching the additional
handle
Attach the additional handle
o
the left or right side of the product,
based on your preferred working style.
˜ Attaching/removing the
accessory tool
Fig. D
WARNING!
m
Before making any adjustments:
Al ays s itch the product off
remove the battery pack
let the product cool down!
CAUTION! Risk of injury!
m
Accessory tools can be sharp
and may become hot during use.
Always wear protective gloves
when handling accessory tools!
CAUTION! Risk of injury!
m
When the product is in operation:
u
Keep your hands away from the
accessory tool.
After the product has been switched
u
off The accessory tool continues
moving for some time. Do not touch
the accessory tool and do not
attempt to brake it.
NOTE
This product is equipped with a
u
Röhm drill chuck with an anti-lock
function.
If you attempt to open the fully
u
opened chuc
anti-lock function will be activated to
protect the chuck.
onto
[ ]
and
[ ]
further, the
2 ] [
NOTE
When the anti-lock function is
u
activated the chuc
closed by turning the chuc ring
in a clockwise direction. A ratcheting
sound will be produced when you
attempt to close the chuck.
This product is equipped with an
automatic spindle lock to open or close
the chuck with the chuck ring
[ 2 ]
1. Open the chuck
ring in counter-clockwise direction.
1 ] [
2. Insert a suitable accessory tool into the
chuck as deep as required.
[ 2 ]
3. Close the chuck
accessory tool in position. Turn the
chuck ring in clockwise direction.
1 ] [
˜ Trial run
ATTENTION! Risk of product
m
damage!
S itch the product off immediately
u
if:
the accessory tool is not running
–
smoothly
if considerable vibration occurs
–
if you hear abnormal noises
–
NOTE
Always carry out a no-load trial run
u
before starting work and after every
accessory tool replacement.
Before operating the product:
o
Check whether the accessory tool is
correctly positioned, i.e. centred in the
chuck .
2 ] [
Screw bits are labelled according to
o
their dimensions and their shape.
If you are uncertain, always check
hether the bit fits tightly in the scre
head without any free play.
cannot be
2 ] [
1 ] [
.
1 ] [
: Turn the chuck
2 ] [
: Hold the
2 ] [
GB/IE/NI/MT 17