Parkside PSBSA 20-Li E4 Bedienungsanleitung Und Originalbetriebsanleitung Seite 12

Work area safety
1) Keep work area clean and well
lit. Cluttered or dark areas invite
accidents.
2) Do not operate power tools in
explosive atmospheres, such as in
the presence o
gases or d st. Power tools create
sparks which may ignite the dust or
fumes.
3) Keep children and bystanders
away while operating a power
tool. Distractions can cause you to
lose control.
Electrical safety
1) Power tool plugs must match the
outlet. Never modify the plug in
any way. Do not use any adapter
plugs with earthed (grounded)
po er tools. Unmodified plugs and
matching outlets will reduce risk of
electric shock.
2) Avoid body contact with earthed
or grounded surfaces, such as
pipes, radiators, ranges and
re rigerators. There is an increased
risk of electric shock if your body is
earthed or grounded.
3) Do not expose power tools to rain
or et conditions. Water entering
a power tool will increase the risk of
electric shock.
4) Do not abuse the cord. Never use
the cord for carrying, pulling or
unplugging the power tool. Keep
cord away from heat, oil, sharp
edges or mo ing parts. Damaged or
entangled cords increase the risk of
electric shock.
5) When operating a power tool
outdoors, use an extension cord
s ita le or o tdoor se. Use of a
cord suitable for outdoor use reduces
the risk of electric shock.
10 GB/IE/NI/MT
amma le li ids
6) If operating a power tool in a
damp location is unavoidable, use
a residual current device (RCD)
protected s ppl . Use of an RCD
reduces the risk of electric shock.
Personal safety
1) Stay alert, watch what you are
doing and use common sense when
operating a power tool. Do not use
a power tool while you are tired
or nder the in
alcohol or medication. A moment
of inattention while operating power
tools may result in serious personal
injury.
2) Use personal protective
e ipment. Al a s
protection. Protective equipment
such as dust mask, non-skid safety
shoes, hard hat, or hearing protection
used for appropriate conditions will
reduce personal injuries.
3) Prevent unintentional starting. En-
s re the s itch is in the o -position
before connecting to power source
and/or battery pack, picking up or
carr ing the tool. Carrying power
tools ith your finger on the s itch or
energising power tools that have the
switch on invites accidents.
4) Remove any adjusting key or
wrench before turning the power
tool on. A wrench or a key left
attached to a rotating part of the
power tool may result in personal
injury.
5) Do not overreach. Keep proper
footing and balance at all
times. This enables better control
of the power tool in unexpected
situations.
ence o dr gs
ear e e