Parkside Performance PDSSAP 20-Li D3 Bedienungsanleitung Und Originalbetriebsanleitung Seite 41

˜ S itching on/o
WARNING! Risk of injury due
m
to unintentional continuous
operation of the product!
Before inserting the battery pack
u
check that the on/off switch
works properly and returns to the
OFF position when released.
Switching on
1. Insert the battery pack
"Inserting/removing the battery pack").
2. Set the rotational direction (see
"Setting the rotational direction").
3. Select the speed level (see "Selecting
the speed level").
4. Press and hold the on/off switch
S itching o
1. Release the on/off switch
2. Wait until the product has stopped
before placing it down.
3. When taking a break: Push the
rotational direction switch
middle position. This prevents the
product from being switched on
accidentally.
4. Remove the battery pack
product if you are leaving the product
unattended or if you have finished
working.
˜ Speed control
Progressively controlling the speed:
o
Apply gentle or stronger pressure on
the on/off switch
Pressure
Gentle
Strong
40 GB/IE
[ 6 ]
[ ]
(see
6 ] [
.
[ ]
.
[ ]
to the
[ 3 ]
from the
[ 6 ]
.
[ ]
Speed
Low
High
˜ LED work light
NOTE
Improve visibility in poorly lit areas:
u
This product is equipped with a
LED work light
,
immediate working area.
As soon as the product is switched
on: The LED work light
immediately.
˜ Belt clip
CAUTION! Risk of injury!
m
Before hanging the product on a
u
belt: Push the rotational direction
switch
3 ] [
This prevents the product from being
switched on accidentally.
Hanging the product on a belt: Use the
o
belt clip
7 ] [
ou can use the belt clip
opener for bottles with crown caps.
˜ Working instructions
NOTICE!
m
Always follow the manufacturer's
u
instructions for tightening screws
or nuts. Follow the manufacturer's
guidelines for the inspection of
screws or nuts in accordance with
time or performance.
After changing a vehicle s wheel(s):
u
Inspect the wheel bolts or nuts as
requested in the manufacturer's
instructions or guidelines. Tighten
the wheel bolts or nuts with a torque
wrench after approx. 50 to 100 km.
to illuminate the
[ ]
switches on
[ ]
to the middle position.
.
as a bottle
7 ] [