Programming Colour Transition Period; Using Several Control Elements - Sentiotec WAVE.COM4 Bedienungsanleitung

OPERATING INSTRUCTIONS

8.3.0 PROGRAMMING COLOUR TRANSITION PERIOD

This is the time the LED control takes on change of colour (manual or at the end of the interval
period), for the colour drift from the current to the next colour.
1. On the control element with the
2. Press the
ber in the process!)
3. With the keys, the colour transition period is extended or shortened. Each change of the
colour occurs with this programmed time.
4. The

8.4.0 USING SEVERAL CONTROL ELEMENTS

For several colour control elements to be used, each must have a separate address(0-3). The
control elements have the address 0 ex works. The address is changed as follows.
7. Disconnect 4-pin bus/supply cable from the control element
8. Simultaneous pressing of the
9. Plug in cable again when pressing the key.
10. Display flashes and the address set for this control element appears.
11. Change address with
1 2 . Confirm inputs with
programming" (see 8.5 master/slave colour control element programming)
WE DO IT FIRST.
simultaneously for approx. 3 sec. (NB: do not change the colour num
takes you back to the mode "Automatic Colour".
or
go to mode "Automatic Colour".
keys.
key
and jump to the "Master/Slave colour operating element
45/52