General; Introduction; Safety Notices - Sentiotec WAVE.COM4 Bedienungsanleitung

OPERATING INSTRUCTIONS
1.0.0

GENERAL

1.1.0 INTRODUCTION

Welcome to the user manual for the innovative, high-tech LED coloured lamp from ABATEC.
This user manual is designed to help you connect the LED coloured lamp to the appropriate parts
of the sauna control "wave.com4" and put them into operation.
This device allows the LED coloured lamp to be controlled by the colour control element of the
sauna control and the LED power element (ASFA22). You can operate the colour control in 2
connection modes. (The setting is described in Item 8.5.0)
a) Single – control element master - mode
Pure colour led control, no sauna function, can only be operated with one control element.
Hardware (connected to the bus bar):
one colour control element and
one or more LED power elements + associated LED coloured lamp
b) Sauna – control element slave - mode
The colour-led control is integrated into the sauna control and the control element acts as a
slave here.
Hardware (connected to the bus bar):
Colour control element(s)
the sauna base section
one or more LED power elements + associated LED coloured lamp

1.2.0 SAFETY NOTICES

Please be aware that the components in the housing of the wave.com4 are operated with
dangerous mains voltage.
Do not connect or disconnect any live components! Always isolate the mains connection
beforehand using the appropriate circuit breaker in the building's distribution system.
30/52