Activating The I Feel Function; Replacing The Remote Control Batteries - Dometic Freshjet Fjz Bedienungsanleitung

EN Dometic FJZ
To activate the sleep function proceed as follows:
a) Set the required temperature
b) Press the button on the remote control or the
The symbol appears in the remote control display. The sleep function is activated.
To deactivate the sleep function, press the
control panel.
The symbol disappears in the remote control display. The sleep function is deactivated.
9.5.9

Activating the I feel function

When this function is active, the remote control measures the room temperature and transmits this measurement to
the roof air conditioner every 10 min . The roof air conditioner adapts the target value to this measurement. The I feel
function is only active when the temperature range is between 18°C ... 29°C.
The remote control should not be kept in a part of the room that is considerably warmer or colder than the average
room temperature. For example, don`t leave the remote control in the sun or in front of the roof air conditioner.
When the temperature rises above 29°C or falls below 18°C , the I feel function is deactivated. The
three times in the display and then turns off.
1. Press the button.
The I feel function is activated.
The symbol appears in the display.
2. Position the remote control so that it points at the IR receiver on the control panel. Otherwise, the values cannot
be transmitted to the roof air conditioner.
9.5.10 Operating the ambient lights
WARNING! Risk of injury
By law it is forbidden to use the external lights when driving the vehicle.
The button on the remote control is active even if the remote control is switched off.
Only for models with ADB light:
To switch the internal lights on or off, press the
The symbol flashes once in the display of the remote control when the internal lights are switched on.
To dim the internal lights, proceed as follows:
a) Press the button on the remote control or on the control panel for 3 s .
b) When pressing the
50 % and 100 % .
c) When pressing the
100 % . Release the
Only for inverter models:
To switch the external lights on or off, press the
9.5.11

Replacing the remote control batteries

NOTE The remote control display may still be bright even if the batteries are running low. Replace the
batteries when the remote control indicates low batteries.
24
(Setting the temperature
or the
button on the remote control, press the
button on the control panel, the internal light's brightness cycles between 50 % and
button when the desired brightness is reached.
on page 22).
button on the control panel.
button on the remote control or the
button on the remote control or on the control panel.
button to dim the internal light between
button on the control panel.
button on the
symbol flashes